Recomended Tension

[DemotioN]

What tension should i use. Im using not the greatest DIY, a diansheng and im trying to set it but i don't know what i should be aiming for. I set it too loose and 4 pieces came out to i tightened all corners. Now sometimes when i do fast algorithms it looks like the pieces will pop but they don't. Sometimes also the pieces almost pop out and that causes lockups so what do u recommend?

Also how much pressure should i use when testing if an edge will pop, im afraid ill brake something

 

[Shortey]

Just experiment with it. It isn't hard.

 

[KboyForeverB]

I just kinda think loose tensions, see if pops, if it does, REALLY hard tensions, then if that doesn't work, that means go a bit tight but too much, that's what I would recommend.

 

[avgdi]

What I do is loosen all the screws and then do RUR'U' really fast and see if it pops. If it does I tighten all the screws a quarter turn and try again. I do this until it won't pop when I do the alg.