QJ Timer V2 Display Not Working

[J4CM4N]

I bought a QJ timer V2 recently and it just arrived today. It works well, however when it reaches 20 seconds or over it doesn't display the whole time (so at 50 seconds I can only see the bottom half of the 5, at 20 second it only displays the bottom half of the 2, etc.) unless I apply to the display. Does anybody know how I could fix this?

 

[Kattenvriendin]

I'd say contact the seller, and otherwise it would be opening it up and seeing where that loose contact is by testing with the cover off.

Be careful of course.

 

[cubernya]

Put something heavy enough on the corner. Or, take it apart and force it into place (seriously, but don't break it)

 

[jonlin]

My timer has become hypersensitive(meaning it stops at 0.00 all the time).
What should I do?

 

[cubernya]

My timer has become hypersensitive(meaning it stops at 0.00 all the time).
What should I do?

So if you hover above the timer, the light will come on (or stop if it's running)? If so, just get a new one

 

[jonlin]

No, when I start it the red light goes on, as normal, but the green one just flickers.
I assume It stopped at 0.00

 

[Cheese11]

Try putting pressure on the display. Or take it apart and try to figure out the problem.