New Rubik's Cube

Joined
Sep 15, 2008
Messages
2
Location
Sydney, Australia
Hi guys, I am new to the forums, I have just started cubing and recently bought a new "Rubik's Cube" one of the standard ones from the toy shop. It is FAR tighter than the previous one i bought and am having quite a lot of difficulty turning it. Someone told me that putting sand in it and then using it for a bit could help to loosen it up but does anyone know how else I can loosen it?

Thanks in advance.

Honeyrosedeluxe.
 
Hello HoneyroseDeluxe,

Welcome to the forums! Lubricate it with some silicone based lubricant, it will make it much faster. Sanding also works, however. By the way, how fast are you?
 
Last edited:
sometimes you just have bad luck and buy a crappy storebought cube. but if its brand new, then work it in a little bit. a brand new cube is not at its full potential yet. sometimes it takes a couple weeks of solves to get it moving the way you want it. i would recommend silicone spray (jig-a-loo or CRC work best in my opinion) for a lubricant over sand. ive heard that sand works, but it makes the inside very rough. silicone spray is smooth and makes for a much easier solve
 
For the first few days or weeks (depending on how much you actually cube) just solve the cube to get the cube broken in. Then get some sand paper or a file and open the cube pieces and shave the imperfections off. Then use it for another few days, then lube.

Thats what I did for my cube and its fast, very fast but cant cut corners obviously.
 
Thanks heaps for that guys. Usually average around 65-70 seconds. But ive got my 2-look OLL and PLL down now so I am practicing that before i start learning more PLLs.

I put sand in the cube and then sanded it a bit - how should i clean out the sand? Or should i just leave it there?

THanks again.
 
Back
Top