New, rotationless, RUF E Perm for big cubes

[Turns_And_Twists2024]

i found a good E perm that isn't RUD, but RUF, so more ergonomic

Spoiler: E perm that makes you like the PLL

R2 U F' (R' U R U')x3 F U' R2

 

[CornerTwisted]

R' y replacing F' is better

 

[Turns_And_Twists2024]

R' y replacing F' is better

This E perm is supposed to be rotationless, but I'm not gonna stop you you do you

 

[precompsubwr]

Pretty good alg, second alg that shows up for e perm on the speedsolving wiki

 

[Turns_And_Twists2024]

I got a 3.85 E perm with the alg I showed (I know, it's slow, I haven't drilled it much)
and with the normal E perm, I got a 4.70 E perm

 

[precompsubwr]

I got a 3.85 E perm with the alg I showed (I know, it's slow, I haven't drilled it much)
and with the normal E perm, I got a 4.70 E perm

3x3: 0.92 normal, 1.44 new
7x7: 1.52 normal, 2.21 new

I would prefer the RUD one on big cubes but if someone has trouble with D moves then the new alg would be pretty good for them

 

[AJT17]

3x3: 0.92 normal, 1.44 new
7x7: 1.52 normal, 2.21 new

I would prefer the RUD one on big cubes but if someone has trouble with D moves then the new alg would be pretty good for them

You should try this alg, it's not good just interesting
R' D' R U R' D R U' R' D' R U' R' D R U' R' D' R U R' D R U
I did it in 1.38 and the standard in 0.83

 

[precompsubwr]

You should try this alg, it's not good just interesting
R' D' R U R' D R U' R' D' R U' R' D R U' R' D' R U R' D R U
I did it in 1.38 and the standard in 0.83

Also 1.44, I think you drill your algs better than me

 

[AJT17]

Also 1.44, I think you drill your algs better than me

Yeah, 1.38 was a real one-off time, it's usually around 1.5 with some low 1.4's.

 

[Silky]

R U R D R' U R D' R' U' R D R' U' R D' R2 is my favorite, personally