Need held for the the last corners (4x4)

[Pastor]

Ah ok byu, I understand what you mean,but one question of the notation: What is the difference between R and r and so on? Is it the same like (RR) and R?

 

[Jude]

On a 3x3x3, the turn r means a wide turn - that is to say you turn the R face and the inner slice next to it, so the centres etc move aswell. On a 4x4x4 the turn r usually means just the slice inwards from the R face, but sometimes both the R face and r slice turn. The notation is confusing, but generally Rw is used for wide turns and r means the slice only. Just to clear up the questions you asked earlier, if you apply the 2 edge swap (parity) algorithm and then solve the edges again using your normal 3x3x3 method, the corners will now be possible to solve. Hope this helps, good luck

 

[Neutrals01]

hmm...isn't r = only turn the inner right slice and Rw = wide turn(turn 2 right layers together)?

 

[Jude]

Sorry, I think my answer was unclear - I've edited it now so it makes sense You're correct