Nanominx design

brandonw

Member
Joined
Jan 30, 2010
Messages
9
Location
California
WCA ID
2010whit03
YouTube
Visit Channel
Ive been thinking a lot lately about how to make an even numbered minx (i.e. the equivalent of a 4x4 cube) and this is what ive come up with.

The minx would use a v-cube mech... if anyone takes interest ill draw this out in more detail.
The only problem i encountered was inner layer turning, but i fixed this by shaping the stem of the edge to allow for the point made by the centers to pass through.
Drawings are nowhere near scale but if anyone is really into puzzle building and would like to colab i would be more than happy to do the designing.
p.s. i called it a nanominx because nano is the decimal equivalent of giga, and since this will really just be a gigaminx with hidden pieces...
 

Attachments

  • nanominx.jpg
    nanominx.jpg
    88.1 KB · Views: 90
  • nanominxedge.jpg
    nanominxedge.jpg
    64.3 KB · Views: 48
  • nanominxedge2.jpg
    nanominxedge2.jpg
    68.3 KB · Views: 48
So, I don't understand how you propose to do inner layer turns. I don't see a straight cut that goes through the center.
 
Back
Top