MF8 megaminx problem

Dionz

Regular
Joined
Nov 30, 2009
Messages
40
WCA ID
2009BEER02
YouTube
Visit Channel
Hi,

Recently i've bought a mf8 megaminx but there is a problem.
An edge and a corner stick togheter like crazy it almost looks like they've been glued.
So how can I seperate them, I tried to saw them but it didn't work..

~dion
 
Hi,

Recently i've bought a mf8 megaminx but there is a problem.
An edge and a corner stick togheter like crazy it almost looks like they've been glued.
So how can I seperate them, I tried to saw them but it didn't work..

~dion


I used a knife and a hammer =D
 
Send the sellers a email. They'll send you a new one.

Did you try to lube your cube with silicone or Jig-a-Loo?
 
I think it's because the Spray Lube...
Did you use Jig-a-loo?

I agree with Odder
But becarefull tho, you dont want to break it
 
pop the pieces around it out then use an exacto knife to try and cut it or just snap them apart, mine came yesterday, you'll also need to loosen the screws under the centre caps too. and cut/sand off any flash.
 
Umh... So, it's not the evil work of the Jig-A-Loo...

Well, don't hesitate sending your complaints to Popbuying. They will send you crap because they hope you will figure out a way of fixing your problems yourself, but it's their responsibility to ship functional products!

I have had problems with DealExtreme, they send me a new cube, but still broken, so I will email them as long as I don't get my good condition 4x4x4! :P I'm a good consumer
 
pop the pieces around it out then use an exacto knife to try and cut it or just snap them apart, mine came yesterday, you'll also need to loosen the screws under the centre caps too. and cut/sand off any flash.

Don't sand too much, or tighten the screws, 'cause it'll pop like you've never seen!
 
Back
Top