Megaminx unscrewing

coolmission

Regular
Joined
Aug 31, 2008
Messages
229
Location
Luxembourg & Aachen
WCA ID
2009SPAN01
Hey guys

I have been solving my megaminx quite a lot in the last few days and the white side has been unscrewing itself on counterclockwise turns now, resulting in a massive explosion obviously.

What can I do to prevent this from happening? Should I just put some glue on the screw, the insert it, to prevent it from turning at all. That would of course eliminate any adjustments later on :( I would take some pictures, but I only have my webcam and the lighting in my room is horrible.

All suggestions are welcome
 
If you use superglue and wait for it to dry, you don't have to worry about not being able to adjust it in the future. Just don't put glue in and then immediately insert the screw.
 
If I knew. Here's a picture:

SMU.JPG
 
If you don't want to use glue, you can also put some small object between the center cap and the screw. I did it on my chinaminx and it works fine.
 
It's a PVC megaminx, and I have the same problem. I just tightened the side that was unscrewing until it stopped. It's slightly tighter than the other sides, but it's not a big deal. Buying screws and springs from cube4you (2 sets!!!) seems to work really well, but I don't have any to try it right now.
 
Back
Top