Lubricating the cube.

Frist

Member
Joined
Sep 27, 2009
Messages
3
Hi, im from Holland, Jig-a-loo cant be purchased here, is there a simular product in holland like jig-a-loo?

Thx in advance
:p
Frist
 
Checked out the wiki.. ill try griffon but first im gonna find some reviews about it;) I think the halforts silicon spray should also be available in holland.
but whats actually the difference between these lubes, because if it's 100% silicon it must be identical.. ?

Thx for helping guys
 
Oke, I've bought the Griffon® silicon spray, not the small one.. would it make any difference because everyone redirects me to the small silicone thingy
 
Sprays tend to use gases like butane as a propellant. Because these propellant gases are petroleum-based, they can react with/degrade the cube plastic. This is what causes the 'sticky' feel immediately after applying the lube. I usually leave my cube disassembled for about half an hour to let these gases evaporate off.

Personally I'd prefer a propellant-free (ie. non-spray) silicone lube, but haven't yet been able to find a good one in the UK.
 
I don't care much for propellant-free lubes. If you have one that you can spray on, you get a good even coating over the pieces. Silicone without any propellant just drips right off the cube.
 
Back
Top