Lubricating Square-1

Status
Not open for further replies.

byu

Master
Joined
Dec 18, 2008
Messages
2,021
Location
California
WCA ID
2009YUBR01
YouTube
Visit Channel
A few questions.

1) What's the easiest way to lubricate a Square-1, while taking out a minimal number of pieces (I don't like reassembling Square-1s)

2) Will lubricating help the U and D moves, or just the / ?
 
I sliced it, leaving the area exposed. Then I sprayed CRC into the can's cap. After that, I used Q-tip to soak the CRC and wiped on the exposed area.

Or, you can use Puzzleproz lube and just spray it in the direct middle between the top edges.

(I think that made sense.)
 
I just pop out an edge, spray it in there, put the edge back in and mix it very carefully to make sure it gets done well. Lubing sq1 won't make too much of a difference anyway, trust me.
 
I just pop out an edge, spray it in there, put the edge back in and mix it very carefully to make sure it gets done well. Lubing sq1 won't make too much of a difference anyway, trust me.

wtf... are you retarded? First off, never pop your sq-1. 2nd, lubing it helps it a TON. way better than doing 7000 solves.
 
What's wrong with popping it? It never pops in solve.
Also, I recently cleaned out my sq1, then after that it was fine. I lubed it, but it didn't do much at all.
 
just put the straw in the hole in the middle of the U or D face

EDIT: Post 200 =D
 
what i did was i took the long center cap off of the cube, and loosened it with a screwdriver. Then, I siliconed the inside by poking the straw into the gap in the center of the edges and corners.
 
Personally, I did a full disassemble and sprayed every piece and my Sq-1 is super smooth, but of course, since you don't want to do a full-take-apart...

Taking it apart isn't really that hard, as well as putting it together, stop being lazy!
 
Status
Not open for further replies.
Back
Top