Lubing an Bump Cube (Mirror Blocks)

[Teny]

Is it possible? and how?

I tried to pry one of the pieces off, but it seems its stuck on tight, and I dont want to break it. Since its $20 and I got it for less than a week.

Is it even possible lubing the cube without even taking one of the pieces off?

 

[eragg0]

MAYBE it is possible to lube without taking it apart: take your silicone and insert that little tube to it. then just spray between cubies

(I will not quarantee any damage you do to your cube)

 

[cookingfat]

MAYBE it is possible to lube without taking it apart: take your silicone and insert that little tube to it. then just spray between cubies

(I will not quarantee any damage you do to your cube)

I did that and it worked fine, you only need a little bit and it makes a load of difference.

 

[Teny]

So I turn one side till I can kind of see the internal, and just stick the tube in there and spray a bit?

 

[rjohnson_8ball]

So I turn one side till I can kind of see the internal, and just stick the tube in there and spray a bit?

Yes, twist a face 45 degrees and try to spray in there using a tube. (Ideally, it would be better if you could pop an edge out. After a few months of use, that should be easy.) Try to spray the inside surfaces of the cubies that rub against one another. Spraying the core won't help, of course. Be sure to do some twisting soon after spraying so the surfaces do not temporarily weld themselves together. Once the surfaces dry, you should be fine.