LED Cube?

it's not as impressive as you may think. I got one and there's no way to just turn on the LED rather it just comes on and does some little slow blink fast blink thing and then turns off.
 
I was going to try to DIY an internally-lit cube, and stumbled onto this thread. I may buy one and then try to hack it to use one of the center caps as a switch (or something like that). I want to see where the LED/battery goes in the core.

Has anyone disassembled one? Does anyone know of any DIY attempts to do something like this?
 
So, I went ahead and ordered three of the Crystal Cubes from Lightake. Surprisingly, they turn decently, especially for a novelty cube.

I hacked one, as detailed in this blog post -- eliminating the annoying blinking function and wiring past the flaky mercury switch. It worked great as a proof of concept. Now I need to figure out how to build in a power switch. The blog post mentions a couple ideas (tact switch in the core, photoelectric cell, etc.). Any other ideas or suggestions?
 
Last edited:
Thanks! It would be awesome if they produced one that was a little smoother. Perhaps it could be done by modding the pieces? And if the light could be turned on and off by pressing, say, 3 center pieces simultaneously for a second. I would love to play in the dark.

Edit: Or have the on/off switch inside one of the center caps. I'd rather take off a cap than pop a piece and have to use a paperclip...
 
Last edited:
Hard to run wires into the center pieces, since they turn. Also, the centers don't have caps. They have a glued on tile covering a screw.
 
I want to see a solve using one of these cubes in the dark.
Here's one a did last weekend: http://youtu.be/HO7nAMeOw_8

------------

As I posted earlier in this thread, I modded the electronics in the core -- disabling the blinking and using a microswitch to control power (instead of the flaky OEM motion sensor). It works really well.

But, never one to settle, I bought a bunch of extra Crystal Cubes and eventually will work to improve two aspects:

(1) The glowing is somewhat uneven because of where the LEDs are in the core. I may try painting the inside of the core with a translucent white to diffuse/spread the light a bit. (The video exaggerates the unevenness a bit -- it's not as extreme to the eye.)

(2) Relocating the switch so that the paperclip can access it from between pieces (without removing an edge piece).

A more ambitious project would be replacing the slide switch with a momentary one that triggers a latching circuit. It's just really hard to wire a latching circuit with components small enough to fit in the core. I'm way too clumsy at soldering on small components for that. Even fancier would be a way to activate that switch by pressing on a center cap or with a magnet -- or basically any way other than forcing a paperclip down to the core's switch....
 
Back
Top