TimMc
Premium Member
Around 30.05.08 I purchased:
- Black Type A
- Black Type D
I'd like to make two hybrids. I've swapped the cores (including center pieces) but I haven't been able to get the tension right.
Has anyone been able to adjust the tension so that it doesn't pop easily but moves smoothly?
The only way I can think of achieving this is by either cutting the springs down or sanding the cubies. The later can easily take up to an hour if you're sanding by hand. :-/
Your input on creating a nice hybrid cube is more than welcome
Tim.
- Black Type A
- Black Type D
I'd like to make two hybrids. I've swapped the cores (including center pieces) but I haven't been able to get the tension right.
Has anyone been able to adjust the tension so that it doesn't pop easily but moves smoothly?
The only way I can think of achieving this is by either cutting the springs down or sanding the cubies. The later can easily take up to an hour if you're sanding by hand. :-/
Your input on creating a nice hybrid cube is more than welcome
Tim.