Hybrids: Black Type A & D (30.05.08)

TimMc

Premium Member
Joined
Aug 12, 2007
Messages
1,741
Location
Melbourne, Australia
WCA ID
2009MCMA01
Around 30.05.08 I purchased:
- Black Type A
- Black Type D

I'd like to make two hybrids. I've swapped the cores (including center pieces) but I haven't been able to get the tension right.

Has anyone been able to adjust the tension so that it doesn't pop easily but moves smoothly?

The only way I can think of achieving this is by either cutting the springs down or sanding the cubies. The later can easily take up to an hour if you're sanding by hand. :-/

Your input on creating a nice hybrid cube is more than welcome :-)

Tim.
 
http://www.speedsolving.com/showthread.php?t=3884&page=2
Post #15 on this thread has some tests of various fusions of As and Ds.

Cheers :-)

I suppose both hybrids D/A A/D have the potential of being really good. I suppose I'm wondering whether anyone has some tips of preparing these cubes for speed solving.

I guess a file, sandpaper, and some silicone spray is the only way to go...

Tim.
 
I'm not sure that the type A with a type D core will be any good. From what I've noticed, the D is helped somewhat by replacing its core with A's ... essentially (to me) it feels a little "lighter". Whereas the converse with D core inside A, just made the A feel really bad :/
 
Last edited:
I'm not sure that the type A with a type D core will be any good. From what I've noticed, the D is helped somewhat by replacing its core with A's ... essentially (to me) it feels a little "lighter". Whereas the converse with D core inside A, just made the A feel really bad :/

A (centers) D (cubies):
- feels lighter
- pops easily
- hard to get the tension right

A (cubies) D (centers)
- feels a little heavier
- doesn't seem to pop
- might need a bit of sanding to make it that little bit smoother

Tim.
 
Back
Top