How to apply goo-gone in the little bottles?

Regisiew

Veteran
Joined
Jan 27, 2009
Messages
281
Hey everyone, I was wondering on how to apply goo gone. I know some come in the spray bottle, though the one I have is in a little bottle, that you just pour. Since I don't want to get it inside the cracks, how should I apply it? With a rag that has the goo gone in it? Will that be enough?
 
Yeah, Q-Tip is the way to go. When you peel off all the stickers and all the sticky, gross, excess adhesive is on the plastic, just squirt a small amount of Goo Gone into a small dish of some sort. Maybe even use a bottlecap. But afterwards, dip the Q-Tip into the Goo Gone and apply it onto the cube. If you don't want Goo Gone dripping into your cube, then you have to apply the Goo Gone one square at a time, instead of just smearing it all over one side.

After that, just let the Goo Gone work its magic. Leave it idle while you solve a cube or something. 1-2 solves is good enough.

Then you just wipe it off with a rag or paper towel. At first I was amazed by how much better it works than rubbing alcohol.

EDIT: Do one side at a time.
 
Duct tapes a good idea... Though I alread used the goo gone and it ROCKS!!!

EDIT: Oh yea, also, since goo gone has petroleum distillates I had to clean out my cube, because I didn't want anything bad to happen (I needed to clean it anyway). So I used just soap and water, and then rinsed it off, and now I have some water stuck in the hard to reach places inside the cubies. Any suggestions on how to get rid of this quickly? Would a blow dryer melt the plastic, or should I use a q tip, and then just let it dry or something?
 
Last edited:
I'd say Q-tip it, but all you really need to do is dry off the areas that create friction, and also any metal parts (i.e. screws, springs). As long as those stay dry, you're cube should be ok.
 
Back
Top