First DIY

pistelli

Regular
Joined
Sep 18, 2010
Messages
48
Location
Pittsburgh, Pennsylvania
WCA ID
2011PIST01
YouTube
Visit Channel
Hello all,

I just got my first diy cube yesterday. It is a ghost hand 2 cube. It is really really fast compared to the storeboughts I have been using for the past couple of years. Too fast. I tried to tighten it, but it is a bit too tight. I have been messing with the tensions on it, but I can't seem to get them right. Should I just leave it loose and learn to use it that way or keep trying on the tensions? What are your experiences with your first diy? How long did it take you to get used to it?
 
I had a similar problem when I put Maru lube in some of my cubes. I just tightened then, and it seemed to work. Storeboughts are very stiff, so it probably feels loser than it is because you are so use to your storebouht. Just try using the cube for a while without tightening it, and you might find that you are getting fast times. Hope this helped. :)
 
On the first day I got the cube, I did a solve and it wasn't any slower than I usually am. I guess it just feels weird. Also, one of the screws feels like it might be cross threaded. I unscrewed it and rescrewed it to no avail. Any suggestions? Also, which finger(s) do you use to turn f and b?
 
My first is a YJ VVGOO-1 (dunno if i spelled it right) trans glow-green. now is destroyed. for Ghost Hand 2 leave it at factory tension as bigbee said, or 1/2 turns tighten, use LUBIX or Lynx Shock Oil.
 
Well, I got the GH2 and absolutely hate it. It locks up on almost every turn. I pretty much left it as it was, maybe a little tighter. It does overshoot a lot though. I think you will get used to it. My advice, since when I got mine I improved none whatsoever, when I got my AV I dropped my average almost 2 seconds, 18 now, tied my PB about 7 times, which is 12, get the AV or F2. I got both and am improving. All I can say for you.
 
I would say that the Ghost Hand II is not a very good cube. It locks up a lot, not very smooth and it's just a cheap knock-off of the Type-F.
There's nothing wrong with the cube - it's just the way its supposed to be.

They are plenty of better DIYs out there including GuHong, Cube4You, Type A-V etc. etc. etc.
If you don't like very smooth cubes then perhaps you should stay away from the Type-F (F-II) and the GuHongs.
I personally despised the Alpha-V but they are other plenty of D.I.Ys out there. You just have to buy a lot of them until you can find the cube that suits you.

EDIT: I also heard there's a Ghost Hand II mod where you're supposed to sandpaper the corners (Alpha V-mod) and do some stuff to the core that's supposed to make the cube a lot better. I found the thread here on the forum. Maybe you should try it out.
 
Last edited:
...it's just a cheap knock-off of the Type-F.

I keep seeing this claim, and it's complete nonsense. The GH 1 looked a lot like the F-1 inasmuch as it had sealed, pillowed cubies, but the similarities ended there. Totally different feel, very unique plastic. And GH 2 has a very unique washboard surface on the inside of the edges, something the F's have never had.

But yeah, it's still a terrible cube that locks up constantly.
 
Back
Top