Edison cube center caps :(

[rachmaninovian]

Hey guys!
I got my white edison 3x3....long long ago.
The caps keep popping out..after I adjusted the tension of the screws. Putting a small piece of paper does not help, and blu-tack DOES not help either!

They just keep popping out...so much that I've either played with it as if it were a void cube instead of a normal speedcube. I would actually prefer it to my japanese speedcubing kit cube but the caps..irritating thingies they are!

what can I do? I don't wanna superglue the caps

 

[ImNOTnoob]

if one sheet of paper does not help, try using two sheets

 

[DcF1337]

Why don't you want to superglue? It works. Real well.

 

[rachmaninovian]

well, I might adjust the tension of the screws every now and then..so why super glue? Dude, it's just dumb, supergluing the caps of a DIY cube.

 

[hr.mohr]

You could just use a single drop of glue or as suggested, in yet another thread about center caps, use a few drops of nail polish. When it drys it should keep the caps on and still be able to come of if you slide the blade of a knife under the cap.

You could also scratch the sides of the cap so that the dents will keep the cap on.

 

[Fusty]

I superglue my caps. They always pry up later. Just take off all the caps and give it a good amount of solves while tweaking tensions. Glue it down, then later just take a razors edge to the edge of the cap and pry it up.

 

[Neroflux]

super glue, let it dry, put caps back.