Discovered a great applicator for Cubelube.

[jonny guitar]

So, if you have used cubelube, you have more than likely had the syringe go crazy and spurt 20 times too much lube all over the place. I am pretty sure this has happened to everybody and that it would even happen to an accomplished brain surgeon.

So, old Otrivin or other brand Nasal Vaporizers work awesome!!!! You just pry the very top off, clean out, fill with lube and replace the top (with the straw like part in place). This allows you to put a single drop in the spot you would like it, keeps an airtight seal when not in use, the shape allows you to just pop the cube corners and lube the inside easily.

No more wastage and messy accidents.

 

[mkriegs]

yeah, I remember the first time I got cubelube. I used like a third of the syringe on my first spray.

 

[Harris Chan]

I tried to avoid spraying too much, so I was like..."well if I pulled it back a bit first and then push right away it should be easier to control because of the momentum"...apparently I forgot that it was the first time for that syringe, so I pulled back and the lube exploded out (thankfully I didn't open my open to let the lube get into it!!). My floor was waxed smooth

 

[masterofthebass]

I have had no problems with the syringes. All you need is to push everything out into the bottle. Then you pull back and load up the syringe. Since you only need a few drops, you just push it a little so that a drop at a time comes out. No problems at all.

 

[Lucas Garron]

I grip the end of the non-plunger part with my left hand and slowly (but forcefully) slide along the X-bar with my right thumb and side of the index finger. I can get full control, then. :rolleyes:

 

[alltooamorous]

When I first bought Cubelube, I thought you were supposed to use the whole syringe at a time. So I used a lot on my first cube and I finally figured out that you were supposed to only use a little x_x