I'm trying to mod my Rubik's Brand into a reasonable speedcube (maybe the Alphas?), and part of the process involves removing the core/hardware so only the center caps/pieces are left and replacing them with a speedcube core/springs/screws so it can be adjustable. What core and hardware would you recommend? I've been thinking about C4U, but they don't have washers.
Well, I don't know how relevant this is, but as a project cube, I recently put YJ YuLong pieces on a Gans III core. It came out fairly well. I'm not certain whether it's an improvement over the original core, but it certainly didn't hurt.
One word of warning, however: Don't use the 57mm Gans core. It has diagonal support webbing near the center, and I found out the hard way that pieces meant for a normal core won't fit on it properly as a result. You need an original Gans III core, but the ones I got didn't come with the nuts, so I'm using the nuts that came with the now useless 57mm Gans core with the original Gans core, and the springs, washers, and pieces of the YJ Yulong. I call it my Franken-Cube, and it's still a work in progress.
To be clear, this is not a recommendation, per se. I just wanted to point out that you can sometimes use the original Gans core with pieces made for a larger cube, just so long as you avoid the 57mm core. In your case, you would also need a hardware set that includes springs and washers, and you would need appropriate nuts to fasten the centers to the core.
And I agree with the previous poster than Dayan makes quality metal parts. Their washers are thicker and more solid than most others I've seen on cubes. But the cheapest route might be to get the original Gans cores and the Gans hardware set. You'd have enough parts to remodel two cubes, and for only a little over $3.