Cleaning, Lubing, and Stickering

[keyboarddrummer]

I have a 3x3 Rubik's that I am going to resticker. I watched a video on how to apply stickers and how to clean and lubricate a 3x3 (take apart, clean in a sink with warm water and soap, lube, reassemble). The video for applying stickers said to take the old off, clean with rubbing alcohol or "Goo Gone" (something along those lines), and reapply the stickers.

What would be the best crossover step? What I mean is I want to do both together to try and save time. So if I remove the stickers first, then clean with soap and water, would I still have to go get rubbing alcohol to clean the old adhesive off?

Sorry if this is in the wrong section, I am new here and thought this was the proper place.

 

[teller]

If it's just stickers, you don't need soapy water or anything...just peel them off and get a paper towel and rub some Goo Gone on there until the Goo is completely Gone.

 

[keyboarddrummer]

Thanks, but I was talking about cleaning the core and the internal parts of the cube so that my cube will not only look good, but turn good too. I found tutorials for this on Youtube, but I don't know how to do them together.

 

[cuberkid10]

Insted of using Goo- Gone, just use the sticker to pick up and extra adhessive. It works for me. And if there's some still left over, just run the cube under some water.