Can't take off residue from QJ 4x4 Tiles

[Andreas737]

I was just taking off the tiles of my QJ 4x4 and what I had left over was this foamy plastic stuff left over from the tiles. I'm trying Goo-Gone but it doesn't seem to do anything! Any suggestions? I have a picture (it's fuzzy cause I can't find my camera) and the color of the residue is the same as the previous tile.

 

[Carson]

Had the same issue when I "detiled" my mefferts. I ended up using a dremmel with a sanding bit, and then went back over with a polishing bit.

 

[Andreas737]

Had the same issue when I "detiled" my mefferts. I ended up using a dremmel with a sanding bit, and then went back over with a polishing bit.

Ok, I guess I'll have to do that then.. is there any specific type of sanding bit I should use?

 

[AvidCuber]

Yeah, I had that too. But I just sanded it with sandpaper, just a tiny bit for every cubie. And I didn't polish it either; and the stickers don't have bumps or bubbles or anything.

 

[Carson]

Had the same issue when I "detiled" my mefferts. I ended up using a dremmel with a sanding bit, and then went back over with a polishing bit.

Ok, I guess I'll have to do that then.. is there any specific type of sanding bit I should use?

If you go this route, just pick a medium "grit" bit. Anything too course and you will end up butchering the cubies... the one I used was probably a little too course but it worked out ok. I can't give you an actual number for the bit, as I don't have the original packaging that any of mine came in.

 

[DavidWoner]

I just left it there. Doesn't bother me.