Caltech Fall 2010

Maru 4x4's and handing out stuff

I'm going to be there too. I would like to buy some Maru 4x4's (and other Maru cubes), so please tell me how much it will cost.
 
Maru 4x4's will be $20. Face-turning octahedron will be $20, and 3x3's, DIY's, 2x2's and Barrel Cubes would be $10

I can ship to you... I don't know that the cubes will be available in person at the competition. So you would have to pre-order.
 
No BLD? I guess I should start practicing 2x2 and Square-1 instead. If 4x4 is held, will there be a cutoff? I'm averaging just under 2 minutes right now.
 
Not planning it at this point. It's a good 6 hour drive... a lot of time. Unless other people from Northern California are going... I dunno. I guess if flights were cheap I could consider it. But it's a lot of time.
 
This is my first competition in a year that I can do 4x4.
First caltech: Had no 4x4, was stupid and too nice to ask to borrow one
DSC and Nisei: Didn't have the event
Rancho Palos: 1:30 cut off :3

Not planning it at this point. It's a good 6 hour drive... a lot of time. Unless other people from Northern California are going... I dunno. I guess if flights were cheap I could consider it. But it's a lot of time.
But Chris from NoCal is flying over hia :)
 
Last edited:
Not planning it at this point. It's a good 6 hour drive... a lot of time. Unless other people from Northern California are going... I dunno. I guess if flights were cheap I could consider it. But it's a lot of time.

I may be driving down there, don't know if you'd want a ride with me or not =p

Plane tickets are about $100 for a round trip, so not all that bad, but still kind of steep.
 
Back
Top