breaking in my edison

CubeNoob1668

Regular
Joined
Jun 26, 2009
Messages
36
Location
Colorado
WCA ID
2009PIER02
YouTube
Visit Channel
so I just got my Edison cube today from Tribox, and I'm just wondering what you guys think on breaking it in. Should I lubricate it now or should I wait until after I've done a few hundred solves. I've also heard in a few places that it might be good to use vaseline to break it in, clean it, and then lubricate using Jigaloo or CRC. Let me know what you think. thanks guys
 
I happen to be holding a white edison in my hands at the moment, so I can try to be of some help.

It comes from Tribox lubed, if you haven't noticed already it should be VERY easy to turn and solve with.

Do about 100 solves with it, then DON'T CLEAN IT OUT. instead, do the BM (badmephisto) lube method and take out 2 top opposite edges, spray some CRC, put it back in, turn it for a bit, then flip it over and do the same thing.

Work it in for two minutes and you have the most insane corner-cutting, fast-spinning rubik's cube that I currently know of that NEVER pops (as long as you don't adjust it).

I can get averages of around 23.5x-ish if I'm warmed up with this cube, and my current competition average was 24.59 with a Type-A II. goes to show you what I SHOULD HAVE used.

But meh. This is an awesome cube. Never put it away.
 
Back
Top