Black Ghost Hand

Ok, here are more pictures. A few notes:

- I tried to get a decent picture, but it looks like each edge piece has an indention on it, but not in the center (of the edge piece), closer to the center piece.

- As you can see, a sticker is already ripping/peeling. I've played with it only a few hours.

- As you can see, the center caps don't pop off.

- It can cut easily from the degree shown.. it's very loose.

...However lemme say.. after playing with it a few hours I'm actually starting to quite like it. It has some trouble lining up but its so fast otherwise.. Also, I can easily U2 it with one flick, sometimes even overshoot that. Haven't bothered to try to implement that in a solve - just an observation. Could probably loosen my c4u to that point..

http://phases.shutterfly.com/1016

Edit: Also, it shipped un-lubed.
 
Last edited:
Ok, here are more pictures. A few notes:

- I tried to get a decent picture, but it looks like each edge piece has an indention on it, but not in the center (of the edge piece), closer to the center piece.

- As you can see, a sticker is already ripping/peeling. I've played with it only a few hours.

- As you can see, the center caps don't pop off.

- It can cut easily from the degree shown.. it's very loose.

...However lemme say.. after playing with it a few hours I'm actually starting to quite like it. It has some trouble lining up but its so fast otherwise.. Also, I can easily U2 it with one flick, sometimes even overshoot that. Haven't bothered to try to implement that in a solve - just an observation. Could probably loosen my c4u to that point..

http://phases.shutterfly.com/1016

Edit: Also, it shipped un-lubed.

Yeah, that is not a ghost hand.
 
no that's not a type d cube. it's a clown cube second verson.

i saw it on PTT rubik's. let's see if i could find the thread....
 
Back
Top