About SQ-1 turning and lubrication

lTianTianl

Member
Joined
Dec 29, 2008
Messages
14
Hi I have a MF8 Square-1(aka DIY square-1 on some stores)

the middle slice turns very well, very smooth

but the U and D layer (as like speaking of a 3x3) don't turn very well, its kind of tight even I already loosed the screw.

Is it normal? how can you make it better?

Thank you.
 
Yes I did lube it, it made the middle slice crazyly smooth, but the U and D layers are still tight and not that smooth like a 3x3
 
Lubing it in the inside makes the / turns smoother. The rest of the pieces roatate around a circle type thing on top of the middle pieces. You can just turn it 45 degrees and lube the pieces that stick out, but it can easily get too loose.
 
I just lubed my sq1 (after breaking in for a week) and it's ultra smooth (I do have to watch out not to make mistakes when turning)

It's the same type as yours so it's not always stiff
 
what i did to make the top and bottom layer turn good was i took the cap off which showed the rails that the peice goes on then i sprayed it on that with jig a loo and that made it smooth
 
Back
Top