A faster Dayan Lunhui

  • Thread starter Thread starter Deleted member 12389
  • Start date Start date
D

Deleted member 12389

Guest
Unlike my first lunhui, my second one did not perform to expections.

Recently, I tried a suggestion from this forum: remove the anchors from my lunhui. Result -it was OK but I felt I no longer had a "lunhui".

I realised that the problem was the anchors which were scrapping the pieces (instead of just acting against pops), adding to the friction. Further, when I pressed down on the anchors, the edge piece (the 2 halves) automatically became loose. There was certain pressure exerted by the anchors against the edge piece which is transferred to the corner pieces in assembled state. Basically the anchor caused the edge piece to expand slightly, pressing against the adjacent corners.

You can see a pic of the connection between the edge and corner pieces in Waffle's mod (for the lingyun- 4th pic) here: http://www.speedsolving.com/forum/s...-Anchor-Pieces&p=596976&viewfull=1#post596976
(credit = waffle)

What I did last night was simple: with a knife, I shaved off the bottom (edge) of the corner piece (substantially). I made sure I rounded sharp edges (existing or created).

After lubing and re-tensioning, I found it is much faster (close but still can't be compared to my lingyun). It feels like a loose guhong.

Note: how much to shave off? I did a face, re-assembled it and tested it. But you really don't want to overshave, you may too loose a cube which 'wobbles'.

Caveat - do this at your own risk.
 
If you have Lubix use that, I did that to my friends. I took out the extra washers (they have 2 in each center) and then lubed it like lubing a Ultimate Guhong, and it was quite fast.
 
If you have Lubix use that, I did that to my friends. I took out the extra washers (they have 2 in each center) and then lubed it like lubing a Ultimate Guhong, and it was quite fast.

Yes, I did it to my lunhui's - first one was great. This second lunhui - I suspect it is one of those "problem" ones.

Thanks.
 
It seems that everyone who has a pre assembled Lun Hui, had 2 washers in each center. I'm trying to figure out why this is. First of all, are these 2 washers both together, on the same side of the spring, or one on each side of the spring, as you would do with an old type A cube? Second, I've noticed on mine that to have it at a decent tension, I have to have it set to such a point where there are good amounts of screw threads are inside the center piece. Could this be why they put 2 washers in the centers, to allow you to tighten the screw more, so the threads aren't sticking inside the center? I'm not sure if that would even help.

Any insight?
 
Back
Top