D
Deleted member 12389
Guest
Unlike my first lunhui, my second one did not perform to expections.
Recently, I tried a suggestion from this forum: remove the anchors from my lunhui. Result -it was OK but I felt I no longer had a "lunhui".
I realised that the problem was the anchors which were scrapping the pieces (instead of just acting against pops), adding to the friction. Further, when I pressed down on the anchors, the edge piece (the 2 halves) automatically became loose. There was certain pressure exerted by the anchors against the edge piece which is transferred to the corner pieces in assembled state. Basically the anchor caused the edge piece to expand slightly, pressing against the adjacent corners.
You can see a pic of the connection between the edge and corner pieces in Waffle's mod (for the lingyun- 4th pic) here: http://www.speedsolving.com/forum/s...-Anchor-Pieces&p=596976&viewfull=1#post596976
(credit = waffle)
What I did last night was simple: with a knife, I shaved off the bottom (edge) of the corner piece (substantially). I made sure I rounded sharp edges (existing or created).
After lubing and re-tensioning, I found it is much faster (close but still can't be compared to my lingyun). It feels like a loose guhong.
Note: how much to shave off? I did a face, re-assembled it and tested it. But you really don't want to overshave, you may too loose a cube which 'wobbles'.
Caveat - do this at your own risk.
Recently, I tried a suggestion from this forum: remove the anchors from my lunhui. Result -it was OK but I felt I no longer had a "lunhui".
I realised that the problem was the anchors which were scrapping the pieces (instead of just acting against pops), adding to the friction. Further, when I pressed down on the anchors, the edge piece (the 2 halves) automatically became loose. There was certain pressure exerted by the anchors against the edge piece which is transferred to the corner pieces in assembled state. Basically the anchor caused the edge piece to expand slightly, pressing against the adjacent corners.
You can see a pic of the connection between the edge and corner pieces in Waffle's mod (for the lingyun- 4th pic) here: http://www.speedsolving.com/forum/s...-Anchor-Pieces&p=596976&viewfull=1#post596976
(credit = waffle)
What I did last night was simple: with a knife, I shaved off the bottom (edge) of the corner piece (substantially). I made sure I rounded sharp edges (existing or created).
After lubing and re-tensioning, I found it is much faster (close but still can't be compared to my lingyun). It feels like a loose guhong.
Note: how much to shave off? I did a face, re-assembled it and tested it. But you really don't want to overshave, you may too loose a cube which 'wobbles'.
Caveat - do this at your own risk.