fii

Hey guys. I've been taking an extended break from cubing. Over the last few months, I managed to accumulate quite a few cubes that I bought for a cubing store and am looking to get rid of them. All of these puzzles are still in the original boxes. I have 7 CII's, an FII, a few mini C's, a...

Hi guys/gals, my FII that I have had for about one month now has started acting up. I replaced the stickers after about one week, and am glad that I did. The problem that I have found is that the caps on the edge/corner pieces keep popping. This started happening today after I applied lube, and...

Hey guys, I am deciding between two cubes: the Dayan Guhong 3x3, and the Shengen FII. Which one shall I get? (And yes, ignore the sticker quality of the FII. I can resticker it.) Also, if it is a Dayan, should I get a Dayan Stickerless cube, the DIY kit, or the assembled version? sorry if i...

Which one is the better

Are there any advantages to having your edge/corner piece caps loose on a type F (II) cube? I know the center caps can be used to tighten cubes, but I find it annoying when I speedcube and a edge/corner cap falls out. Would it be bad to superglue it in?

I just bought an FII on speedcubeshop.com... is it prelubed? if not, is it safe to lube it with jig-a-loo (i just heard about the Dayan Guhong that got destroyed with a type of lube)

Imma doin my science project on the best way to remove crude oil from salt water (I live in Gulf Coast of Florida, so the project should interest many people and be an instant winner). But I've run into a small problem. I can't find anywhere where I can buy like 20 liters of light sweet crude...

F-II edge and corner cap POPping Title I'm aware that this happens often enough, but I'm curious if anybody has found a way to avoid/reduce the amount of POPs? I'd rather not risk messing up with super-gluing them down.