• Welcome to SpeedSolving.com — the world’s largest puzzle community!

    You’re currently browsing as a guest, which means you have limited access to discussions, resources, member profiles, and community features.

    Join 50,000+ cubers and puzzle enthusiasts from around the world to ask questions, share solves, improve faster, and be part of the community.

    Registration is free, fast, and easy — create your account today.

    Already a member? Log in here to hide this message and start participating.

Cuthbert's Open 2013 (UK)

can you please be a bit more vague

:P

If you have a small white Fangshi I will buy one.
Sarah would like a black Weilong please.
Also the previously mentioned 2 bottles of Maru.

Thanks.

We won't be there on Sat, only Sun.

Were you entering time a lot at Cambridge?
 
Preferebly a ss 4x4x4, black moyu huanying, stickers I don't really need but I would be grateful if you could bring some.

If you do bring these products, how would I recognise you?

look for a chinese guy

If you have a small white Fangshi I will buy one.
Sarah would like a black Weilong please.
Also the previously mentioned 2 bottles of Maru.

Thanks.

We won't be there on Sat, only Sun.

Were you entering time a lot at Cambridge?

sure,

what does entering time a lot mean, i wasnt at cambridge
 
Selling a black Dayan Guhong - £8 o.n.o

Just recently cleaned it out, lubed and tensioned it, restickered it with half-bright Z-stickers and turns really smoothly. Negotiate well enough and I may throw in an extra set of stickers as well.
 
how do i dissasemble 54.6mm fangshi thats to tight to take apart and caps wont come of unless dissasembled?
I also had difficulty dissabling my Black/White 54.6mm ShuangRen when I got it. You have turn the top face to 45 degrees, and as you try to take out an edge you have to pull down on the F2L pair below it with your other hand and pull upwards, and then outwards. I still can't get my centre caps off though :(
 
yes please!

i did it, and to get centre caps of i got a pin and pushed on the black holes on the inside of the centre with a pin until a gap formed and i could push up with my nails
 
Last edited by a moderator:
i did it, and to get centre caps of i got a pin and pushed on the black holes on the inside of the centre with a pin until a gap formed and i could push up with my nails
I thought they were screws before. I should probably have look properly at what they were; I didn't realise they were for removing the centre cap.
I got this cube on the 4th of September: it's taken me exactly one month to remove the centre caps.
 
Back
Top