To sand, or not to sand...

Steel wool is good for sanding, it's what I used on my storebought.

+1

Steel wool is the cat's meow for smoothing out a cube. I use on every cube I buy (diy and storebought) just to totally smooth out the molding seams that are part of the manufacturing process. I believe it works better than sanding and is far smoother in the end result -- as an added bonus you would really have to put a lot of effort into screwing your cube up whereas sanding can go bad very quickly.
 
Sanding wouldn't be a good idea for your DIY but it would be an option for a storebought cube. The difference is the plastic, the storebought cubes' plastic is a harder than the DIY (is this a good sentence :s). A DIY without sandig feels also very good.
 
thanks gupper

what about sanding cubies corners only (obviously not ones that don't come in contact with the inside of the cube or adjacent cubies)? wouldn't that aid in better corner cutting? (pun not intended)

also, what about using a metal file to smooth over your springs if there are no washers? (kinda off topic but sanding i guess is like filing)

is it worth is to smooth over your core? (like with steel wool or something relatively unabrasive)
 
thanks gupper

what about sanding cubies corners only (obviously not ones that don't come in contact with the inside of the cube or adjacent cubies)? wouldn't that aid in better corner cutting? (pun not intended)
You could do that, but it wouldn't make too big of a difference. If you want a big difference, get a better core. For example, look at the Type F DIY cube. It's pieces are rounded a lot, but it's not very good at corner cutting. Switch the core to an old Type A core, and it will cut corners much better.
 
Sorry for bumping this old post!

I bought 2 x Type A V, 2 x Type C, 3 x C4U DIY Black.

I sanded down one of the type A V's - it had MAJOR manufactufing bits and pieces that needed to be sanded off (even on the side of corner cubies).

It turned like CRAP. With silicone I managed to make it turn "ok" but it was hard to adjust the tension so that it would turn fairly well and not pop.



For the second Type A V, I only sanded down the manufacturing defect on the side of the small caps for the corner pieces. I left all other defects intact.

It turned well right after assembly, and didn't pop. No lube.



I also ordered 2 Type C's. I did the same experiment. The sanded down cube turned very badly after sanding and would pop if I loosened it even slightly.

The unsanded Type C, turns well (but is noisy).



The C4U DIY's: I've assembled 2 of them without any sanding (they didn't have any obvious defects). The tension was a little harder than usual cubes to adjust. Turned well but popped. Managed to get them just right where they turn well and doesn't pop (popped every time during RUR'U') - but took a while.



I have a theory that when they come up with new cubes, they don't bother to remove manufacturing defects when they are testing the cube. Which is why they often perform well without sanding: they are "forced" to perform well by the designers. They probably alter det individual pieces until the cube performs well.
 
Last edited:
Back
Top