Rubik's 2x2 Cube (2012)

TimMc

Premium Member
Joined
Aug 12, 2007
Messages
1,741
Location
Melbourne, Australia
WCA ID
2009MCMA01
Hello,

I just discovered that a couple of puzzle store in Melbourne are now stocking a new Rubik's 2x2 Cube!

A quick search lead me to this closed thread where it became clear that the new cube is also available online. But there didn't appear to be any photos or a review in the other thread, nor a reason given as to why it was closed. So I'd like to give you my review and share some photos of the parts.

Initial thoughts
It has tiles!
It's small!
It turns well!
It doesn't really cut corners (maybe 10 degrees).

IMO it's better than an ES but would require more breaking in and perhaps some modifications to be able to compare it to a WT or SS.

Photos
Here's an album on imgur with 14 photos of the parts.
*please see titles/description for more commentary about the cube :-)

Tim.
 
I've tried this cube, all I can say is that it is absolutely terrible. It is minuscule really, and for someone with large hands it is just far from ideal. It turns terribly, I'm not sure if lube would make that much of a difference really but a LanLan out of the box is far superior anyway.
 
ILanLan out of the box is far superior anyway.

LL and SS are pretty crap for speedcubing out of the box; just like this R2. The tension should be set properly and the cubes should be lubricated first. WT is usually ok out of the box but a bit of lubricant makes it a lot better.

Most of the cubes I've tried are crap until I take them apart, remove bits of plastic with a scalpel, polish, lubricate with silicone oil 40k cst, re-assemble and then set the tension.

Tim.
 
LL and SS are pretty crap for speedcubing out of the box; just like this R2. The tension should be set properly and the cubes should be lubricated first. WT is usually ok out of the box but a bit of lubricant makes it a lot better.

Most of the cubes I've tried are crap until I take them apart, remove bits of plastic with a scalpel, polish, lubricate with silicone oil 40k cst, re-assemble and then set the tension.

Tim.

I got 2 LanLans. One I took apart, lubed etc. The other I did nothing. I can't tell them apart. It is more than adequate for speedcubing.
 
How does one actually lube a LanLan?

You have to take a corner cap off. Now you are at the inner mechanism. You must pry out one of the middle pieces, with a screwdriver (or your finger, if you want), and put whatever you are using to lube in there. Then reinsert the piece and reattach the cap. Move the cube around so it doesn't bind

Yeah, it probably won't.

Cameron was getting 2.30 on the R2 today (would've been 1-2 if using a WT). Verdict: It turns smoothly and fast but it's too small and doesn't cut corners.

Tim.
However, it will most likely be sold in toy stores giving very casual cubers a taste of speedcubing.
 
Last edited by a moderator:
You have to take a corner cap off. Now you are at the inner mechanism. You must pry out one of the middle pieces, with a screwdriver (or your finger, if you want), and put whatever you are using to lube in there. Then reinsert the piece and reattach the cap. Move the cube around so it doesn't bind

Well I did that, but that doesn't have any effect. LanLan doesn't need lube, as it doesn't make it better IMO and lubing it is a waste of resources.
 
Back
Top