Eastsheen 2x2

  • Thread starter Thread starter nitrocan
  • Start date Start date
Status
Not open for further replies.
N

nitrocan

Guest
I just got my eastsheen 2x2 today, and it turns great. But it locks up like hell. Is there a way to make it better?
 
yes i have lubricated one of the two eastsheens and i use the non lubricated one
 
and soak it in silicone :D
That makes it cuts corners a lot better after a couple of days, but your cube gets so loose you can do like an R6 or higher. It's also very hard to control. I would not recommend it and I regret lubricating my Eastsheen cube.

i quite disagree.

My ES 2x2 pre-lubing= terrible
My 2x2 post-lubing= honestly the best cube i own.

while it is hard to control at first it only takes a week or so of practice to get used to it. you need to make sure that you take it apart when you lube it, there are guides for this. not only will it provide better lubrication, but just just the act of taking it apart will help loosen it. and like shaden said, be rough with it at first. you will be glad you did.

btw my record with my cube is an R14.
 
and soak it in silicone :D


btw my record with my cube is an R14.



14, bull.

this was back when it was new. my friend took it apart and lubed it for me(since i didnt know how at the time) but he kept putting it back together wrong so he ended up taking it apart 3 times, which made it super loose. to get 14, i held it on a table(to help keep it lined up) with 2/3 of it over the edge and then spun it. i tried many many times because i was fascinated by it. i can still get about 10 with it, even though it is starting to wear out. i take it apart to lube it every month too. i like it buttery smooth.
 
Status
Not open for further replies.
Back
Top