Guhong Screw Anchor Mod Fail

JonWhite

Regular
Joined
Jan 25, 2011
Messages
61
Today I tried the Guhong screw anchor mod with size 4 pan head screws. Now, the black face of the cube is functioning pretty badly -- it's extremely loud and clicky, and the face will "snap" into a position misaligned by several degrees. I've examined every single edge piece, and none of the screws are rubbing against the core. I've switched each half-black edge piece with another non-black piece, and the problem persists. Loosening the black center to extreme levels does not solve the problem, either. All other faces are performing fine. Any suggestions?
 
Did you superglue the screws into the piece?

EDIT: You said you switched 2 pieces, so that it was a non-black piece. Try swapping out all the black pieces for another color (say yellow) and if the problem persists, it's your core
 
Last edited:
Yep, they're superglued.

I'll try some more piece-swapping soon (don't have the cube atm). However, I don't understand how the problem could be the core if I've never had these problems before this mod.
 
The only other thing I could think of is that the hole for the screw isn't big enough, so that the piece is open
 
All the pieces are closed.

I've also noticed that the orange face has the similar audible "snap" into a position misaligned by several degrees.

I switched all black pieces for yellow (with M2 U2 M2 U2 x U2 M2 U2), and the black face (with black center) is still loud with the odd "snap". The yellow face is then much louder than before, but without the "snap". Upon switching orange for red, the orange face doesn't "snap" while the red does.

In solved state:
black -- loud, snap
yellow -- smooth
orange -- snap
red -- smooth

after switching black-yellow and orange-red:
black -- loud, snap
yellow -- loud
orange -- smooth
red -- snap

I see no pattern here... D:
 
Last edited:
The orange pieces are making it snap, the black pieces make it loud, and the black side of the core you need to look at (make sure it's screwed in strait)
 
found the problem: hard-to-see accidental drops of glue on edge pieces, underneath the screw head. I scraped all of them off, and now the cube is running smoothly again. Thanks guys!
 
Back
Top