I'm going to put my story up again.
I was at 1:00 minute, using a store bought Rubik's brand. Horrible turning and corner cutting. Could only use wrists, no finger tricks.
I then bought an A5, preassembled, with tensions set and prelubed. My times went to 40 seconds, withing 2 days. No learning anything new. The only thing I did differently, was doing finger tricks, since the new cube allowed it, and the Rubik's storebought only allowed wrist turns.
So, I dropped 20 seconds. I stayed at 40, until I started learning PLLs and F2L intuitively.
When someone is in the 1:45 average, they can easily drop 30 seconds, by just beginning to use finger tricks. People saying that they didn't drop 30 seconds when switching cubes, when they averaged 40 seconds, don't get the point. It's a much bigger difference to drop 30 seconds when you are at 1:45, then when you are at 40 seconds.
Dropping 1:45 to 1:15 can easily be achieved with finger tricks, which can be used on speedcubes, and sometimes impossible on storebought Rubik's brands. Dropping below 40 seconds means you have to start learning F2L, and to go even further, even some PLLs.
So, stop giving ridiculous examples, such as saying you didn't drop from 40 secs to 10 secs, because of a cube.
And trying to compare 1:45 on a 3x3 is not the same as 1:45 on a 5x5. Obviously dropping 30 seconds at that average, on a 5x5 is much harder, than dropping 30 seconds on a 3x3, when you are averaging 1:45.