Do AV's respond well to Jigaloo?

vancuber

Member
Joined
Aug 14, 2010
Messages
20
Well, I got my AV, modded it, lubricated it with maru lube, and its been popping a lot, so I decided to adjust the tensions and make them tight. Once I tightened them, it was too tight and I didn't like it, so I put two additional drops of maru lube. Barely a difference. I put my tensions back to the normal, and its o.k., I LOVE the speed, but hate the popping, which happens 1/2 solves. I remember putting jig a loo in my rubiks brand, and it would over spin a lot. I was thinking that if it creates the same effect on my AV, and I tighten the screws, it would work. Before I try it, does anyone have any experience with doing this? I once saw a post that said that jigaloo will melt down the teeth on the edge pieces that are supposed to prevent popping...the teeth obviously don't work. Any other recommendations outside of jigaloo or anything would be highly appreciated.
Also, living in Canada, I don't have access to lubricants like CRC
 
The "teeth" work fine: if it's popping, you have it too loose. Tighten it, lube it properly (ie dismantle first, let it dry). Everyone else's AV is a good cube. Learn to turn accurately! Have I said everything in the FAQ yet? :)
 
Last edited:
Back
Top