Dfgged
Regular
dunno sbout alpha4, but if its similar to alpha5, then it will be bad, cos...
TEH ALFER 5IVE IS KRAPPY
That's because you have a stripped core!!!! GET A NEW F***ING CORE!!!!
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
dunno sbout alpha4, but if its similar to alpha5, then it will be bad, cos...
TEH ALFER 5IVE IS KRAPPY
dunno sbout alpha4, but if its similar to alpha5, then it will be bad, cos...
TEH ALFER 5IVE IS KRAPPY
don't get me started
did you mean "the big washer" are washers that made from plastic?
Can you explain the teory behind the picture?
i dont really get the point from the picture about making the cube faster..:confused:
anyway, i like the A4
it does lock up, but it's not that bad. it cuts corner quite good too tho, and I think it's the cheapest from all Guo Jia Alpha 3x3x3 series (exlude the minis)
did you mean "the big washer" are washers that made from plastic?
Can you explain the teory behind the picture?
i dont really get the point from the picture about making the cube faster..:confused:
anyway, i like the A4
it does lock up, but it's not that bad. it cuts corner quite good too tho, and I think it's the cheapest from all Guo Jia Alpha 3x3x3 series (exlude the minis)
gosh, do you still not get it, having seen such a obvious diagram?
the plastic washer have the same outer radius as the big washer, and the inner radius is larger than the springs'. this means that with the same gap setting, the one with plastic washers will have more room for the spring than the one without, hence less normal force applied upon the cubies.
this is kinda similar to removing the small washer or cutting the springs, as it compresses the spring less under the same gap setting. but since removing the small washer causes the center piece to wear out, this would be the best way to make your cube pop less.
I'm not going to mention anything about the corner cutting and the popping resistance, but this cube can cut 45 degrees even at a tight tension and it does not pop.
I'm not going to mention anything about the corner cutting and the popping resistance, but this cube can cut 45 degrees even at a tight tension and it does not pop.
:confused:
anyway, sounds like a good cube!
So was he gonna tell us or not??:confused: