QJ Pyraminx Mods?

I put out 1/3 balls on every side , and now its pritty good

that will make it pop when broken in...

Yes, there exist a mod, but pretty hard to perform :/ so I haven't done it on more than 1 of mine :P

just file the centers (where the edges meets) so the edges have more place to "cut corner"... this should resist some lockups, but might make it pop more often... but it took me like WAY too much time xD

but it's very fine without, even though I get kind of pissed at them when they lock up xD
 
oh any way to make the tip not fall off? I adjusted the tension a bit and now it falls off during solves
 
I put out 1/3 balls on every side , and now its pritty good

that will make it pop when broken in...

Yes, there exist a mod, but pretty hard to perform :/ so I haven't done it on more than 1 of mine :P

just file the centers (where the edges meets) so the edges have more place to "cut corner"... this should resist some lockups, but might make it pop more often... but it took me like WAY too much time xD

but it's very fine without, even though I get kind of pissed at them when they lock up xD

It never pops
 
I put out 1/3 balls on every side , and now its pritty good

that will make it pop when broken in...

Yes, there exist a mod, but pretty hard to perform :/ so I haven't done it on more than 1 of mine :P

just file the centers (where the edges meets) so the edges have more place to "cut corner"... this should resist some lockups, but might make it pop more often... but it took me like WAY too much time xD

but it's very fine without, even though I get kind of pissed at them when they lock up xD

It never pops

You wanna bet?
 
My pieces are always loose so i have to tighten the screws to make it not all loose. Any ideas on how to fix this?
 
Back
Top