Not-so-good Square-1?

SaberSlash49

Veteran
Joined
Jul 9, 2009
Messages
251
Location
Mansfield, Texas, United States
WCA ID
2009NGUY07
I got my MF8 Square-1 about 2 weeks ago and I've been messing around with it here and there, and I used Jig-A-Loo, but I haven't noticed any difference (turning-wise) and the top and bottom layers are very rough and slow.

Is there any way I can fix this? Thanks.

- Saber
 
You have to do a couple hundred solves to break it in. Trust me, in the end you'd rather have the layers stiff, now I flick the U face with my finger and it does U3 :mad:
Also adjust the tention a bit but that only affects the / move
 
COUPLE HUNDRED SOLVES? -dies- Anyway, I've already tried experimenting with the tension, and it becomes too loose..

lol sorry if I scared you...Well I do around 50 solves a day so that really isn't much of a problem to me. Don't worry, the roughness will go away in a while
 
I lube my squares-1 by taking off a corner cap and spraying lube right on the track. That's the only way I've found that actually helps the layers.
 
Mine came with a tight spring that if I loosened the slice to my liking, the top and bottom became ridiculously loose. I changed the spring to a trimmed pen spring and it works a lot better
 
No, I've always used the same screw. Just tighten it down and it should be fine.

I suppose it could be a problem, but I've never had to change mine.
 
My MF8 square 1 is very good. But I've done a lot of stuff on it.

First, I loosened the screw a bit, then after a few days, I put this oil stuff into it which made it very good, but after about a month it became extremely sticky and hard to turn, so I took it apart, sanded off the oil stuff, reassembled it and let the sand break it in a bit more. Then I sprayed some polish into it (no disassembly) and that made it worse, so I sanded that off, put it back together, and let the sand break it in a bit more, then after about 2 months, I took it all apart, cleaned all the sand out and whilst it was still apart, I sprayed more polish onto the pieces, let them dry, reassembled it, and now it turns amazingly. [/square1slifestory]

P.S. I dont use proper lube :p
 
Last edited:
Back
Top