Breaking in a storebought

TioMario

Regular
Joined
Oct 26, 2009
Messages
165
Location
Montevideo, Uruguay
YouTube
Visit Channel
I've bought an original Rubik's 3x3 and now I'm trying to tune it to make it better.
The center pieces are too tight, so the friction between the pieces is high. I tried to solve this by putting some toothpaste in the edges and corners and working the cube out for about 3 or 4 solves. Then I washed all the pieces separately, lubricate them with silicone spray (I use something called "Victory") and reassembed the cube.
Now it's worst than before, do you think that with time it will be better?
If not, could you give me some advise?

Thanks!
 
mix. i mean, one of my best cube is a mix of a new kernel and old pieces(both storebought) and it turns very well, so mabe you have to clean al the pieces to remove the lubricant. cubes being hard at the begining is a very common thing so just wait and it will eventualy solve
 
That looks like dirty work. If i break it, I don't have money to buy another one, let's just focus in small mods. Maybe I'll do that with a bigger acquisitive power someday.

Put some sand in it. That will sand off the points of friction. Just put some in, solve it until all the sand comes out, and then take it apart and clean it.
 
Also, when you put silicone in it, make sure to work the lube in really well; i do RUR'*8 from all 24 orientations of the cube to work it in. If that doesnt improve your cube any, you probably need a different kind of silicone spray...
 
3x3 storeboughts will break in faster when they are NOT lubed.
In addition, lubing will not change the tension of your cube.

maybe you want to take your cube apart and put playing cards between the core and the centres.
leave this over night and perhaps put a second card in afterwards and let it rest again over night.

btw, why did you put toothpaste in your cube?
first time, i ever heard of this.
was it just for a better smell or was it supposed to do sth?
 
Back
Top