Maybe try a little piece a paper under where the cap locks in. So cut a small sheet that's ~1/4 the size of the center can and fit it over that little square. Worth a shot.
Maybe try a little piece a paper under where the cap locks in. So cut a small sheet that's ~1/4 the size of the center can and fit it over that little square. Worth a shot.
That really helped, I just cut out small rectangles a bit bigger than the pegs and put them between the peg and cap before putting it on.
Now the center caps are pretty tight btu still able to remove them (only need a small piece of paper in the case it falls out, which is usually not hard to find )