I just bought a white DianSheng no.333 last Saturday. It's painted, has weird looking edges and corners, and the corners are pretty sharp. I lubed it with silicon spray after solving it a few times, and the cube now turns a bit faster.
I did some research about in this forum and a lot of people said that no.333 is not that good, as compared to no.222. Well, I do notice some weaknesses of the cube. Sometimes it locks when I turn too fast, and it does not cut corners very well. Moreover, it's hard to distinguish between the orange and the red. I messed up a lot of solves because of that...
So, is there any way (advice) to turn it into a better cube, or all hope is gone?
P.S: I'm new to choosing cubes and DIYs stuff. My last cube (the first one I bought) was a store bought from Toys R Us.
I did some research about in this forum and a lot of people said that no.333 is not that good, as compared to no.222. Well, I do notice some weaknesses of the cube. Sometimes it locks when I turn too fast, and it does not cut corners very well. Moreover, it's hard to distinguish between the orange and the red. I messed up a lot of solves because of that...
So, is there any way (advice) to turn it into a better cube, or all hope is gone?
P.S: I'm new to choosing cubes and DIYs stuff. My last cube (the first one I bought) was a store bought from Toys R Us.