Wheel Cube/Windmill Cube Last layer switch

[ZCuber99]

I just got the YJ Wheel cube and I solved it using the beg. method. But it isn't solved. 2 corners and edges are swapped (Blue over blue = Done, Orange over Orange = Done, Red over green = not done, Green over red = not done)
Is there a alg to swap them? I have mixed it up a few times and only actually solved it once. I've got this every time except for that one. How can I either get around it or swap them?

Thanks for your help!

 

[DGCubes]

Can you post a picture? I don't have the cube but have solved it before so I might be able to help.

 

[ZCuber99]

Can you post a picture? I don't have the cube but have solved it before so I might be able to help.

Woah! DGCubes, I love ur videos bro! Haha thanks for the reply

 

[DizzypheasantZZ]

I always do 2-look PLL on a windmill cube but here is the one look solution.
Hold the cube as in picture 9 with orange as the front and perform a Ja perm (R' U2 R U R' U2 L U' R U L')

 

[ZCuber99]

I always do 2-look PLL on a windmill cube but here is the one look solution.
Hold the cube as in picture 9 with orange as the front and perform a Ja perm (R' U2 R U R' U2 L U' R U L')

Thank you so much! And I was doing 2 look PLL but i got this case