Rubik's DIY Problem

  • Thread starter Thread starter nitrocan
  • Start date Start date
N

nitrocan

Guest
I've recently bought two Rubik's DIY cubes and assembled, and lubed it. The problem is, it feels very heavy. (not the cube, the turning) I had a JSK before, and it was much easier to turn. Now I have to force myself a little more to turn each side, and the sides don't give equal feelings no matter how much I mess around with the tension. I get approximately the same times since this cube doesn't lock up at all, but a little harder to turn. Any ideas?
 
And another question, the instructions say that I should glue the center caps. How am I going to readjust after that?
 
Wow, I just assembled the second one, and its totally awesome. It's not even lubricated yet. I'm thinking of just throwing the first one out.
 
Well don't glue the caps if you want to adjust them. Umm paper trick or i've heard loctite?
 
You say the sides do not have equal feeling... Perhaps the 6 centers do not have the same tension? Try checking the gap sizes between each center and core (when you pull the center piece outward) to make sure they are the same. Perhaps the screws were not inserted perfectly straight? As for gluing the caps... that is the big thing about the Rubik.com DIY's I do not like. I could not get the paper trick to work, but I haven't retried using thicker paper (like index cards). Would a glue stick be strong enough?
 
RUBIKS.com DIY are amazing. i extended the teeth on caps with some epoxy putty. it holds pretty tightly. and you can still take them out when you need to.

the tension is all trial and error stuff. it took me three hours to get the tension to my liking. its all worth it.
 
The thing is, I get the tension pretty good, do some PLLs to check, it works fine, I put the cube together, put the stickers and its crap again.

EDIT: Accidentally found a way to hold the center caps in place :D :
-Glue the center caps with super-glue.
-Wait for it to dry (mostly 3 minutes)
-Take the center caps off with a knife or such.
-Don't clean the glue marks.
-Put them back on.

Now you can cube without the center caps falling, and you can easily take them off.
 
Last edited by a moderator:
The thing is, I get the tension pretty good, do some PLLs to check, it works fine, I put the cube together, put the stickers and its crap again.

EDIT: Accidentally found a way to hold the center caps in place :D :
-Glue the center caps with super-glue.
-Wait for it to dry (mostly 3 minutes)
-Take the center caps off with a knife or such.
-Don't clean the glue marks.
-Put them back on.

Now you can cube without the center caps falling, and you can easily take them off.

I tried it.. Cant get past the third step.
 
I posted a thread about this not to long ago and got a great reply. Put a little bit of adhesive putty on top of the screw and place the center cap back on. Let it sit for a bit and start cubing and see how it holds. Apply more or less as needed.

Works great for me.
 
Back
Top