Zhanchi Screws

canadiancuber

Veteran
Joined
Mar 9, 2010
Messages
340
Location
Markham, Ontario (anyone else)
WCA ID
2010CHEN01
So i recently bought a zhanchi but when trying to adjust it 5 of the sides were ok, but on the 6th side(green) the screw instead of being a "cross" like its suppose to be it was almost like a circle. It was unturnable. so now all 5 of my sides are different (good) tensions where the sixth is awful. what do i do?
 
I had a similar problem with my SS 5x5. (I ended up mangling the core, ruining some of the screws, then used a new core and new screws with the same pieces). My suggestion is to uy some new dayan hardware and just put the pieces around the new core and use new screws and springs.

You can buy the supplies for only a couple of bucks here:
http://www.cubedepotusa.com/apps/webstore/products/category/338463?page=1

It's going to be a pain to tension this thing, and for only a couple of bucks plus shipping, this option is not too bad.
 
Back
Top