~Phoenix Death~
Legend
Herro,
After blood, sweat, and tears (literally, all that happened) of trying to glue in the pins, I've came up with a tip. I don't anyone saying "STFU, THIS IS OBVIOUS!". This is a tip for those who don't know. If an adult offered you advice, take it, it won't hurt you.
Now onto what I have to say.
When you're done cutting the pin and gluing it in, inspect it. I'll use this picture as an example:
So when you're done gluing it, look at it. If the pin's height goes any taller than the top of the rivet, it's most likely too big. When clipping it, try your best to get it to meet where the red line is or a bit below.
The second way, as explained in MMAP's video, is using the center pieces. You may need the puzzle assembled for this way. Go to this video and look at 16:18. The center piece has a line splitting it in two. The pin should be tall enough to scrap under there.
That's all I have to say. I may edit this if needed.
After blood, sweat, and tears (literally, all that happened) of trying to glue in the pins, I've came up with a tip. I don't anyone saying "STFU, THIS IS OBVIOUS!". This is a tip for those who don't know. If an adult offered you advice, take it, it won't hurt you.
Now onto what I have to say.
When you're done cutting the pin and gluing it in, inspect it. I'll use this picture as an example:
So when you're done gluing it, look at it. If the pin's height goes any taller than the top of the rivet, it's most likely too big. When clipping it, try your best to get it to meet where the red line is or a bit below.
The second way, as explained in MMAP's video, is using the center pieces. You may need the puzzle assembled for this way. Go to this video and look at 16:18. The center piece has a line splitting it in two. The pin should be tall enough to scrap under there.
That's all I have to say. I may edit this if needed.