Garmon
Veteran
I got my V cube 6 this morning, (black) and while I was turning 3 layers really gently (I wasn't even messing it up) I had a huge POP and pieces where scattered on the floor.
I thought I had found all the pieces, and after an hour I had fully assembled, but there was no 'interlocking' piece/ clamp pieces, I was one short (the smaller one).
Anyway, I was actually wondering if the V-Cube company forgot to put one in, since I couldn't find it at all, and why did it POP so badly after such soft turning?
Now I am wondering how I can get a new one of the piece.
http://upload.wikimedia.org/wikiped...assembled.jpg/800px-V-Cube_6_disassembled.jpg
The pieces in the middle right of this photo, below the ones that are similar but bigger.
Also should I still solve it despite the very often pops?
I thought I had found all the pieces, and after an hour I had fully assembled, but there was no 'interlocking' piece/ clamp pieces, I was one short (the smaller one).
Anyway, I was actually wondering if the V-Cube company forgot to put one in, since I couldn't find it at all, and why did it POP so badly after such soft turning?
Now I am wondering how I can get a new one of the piece.
http://upload.wikimedia.org/wikiped...assembled.jpg/800px-V-Cube_6_disassembled.jpg
The pieces in the middle right of this photo, below the ones that are similar but bigger.
Also should I still solve it despite the very often pops?
Last edited: