I was replacing the pins inside of my v6 but the glue came out to runny and now it cant turn with out moving the rivet and the spring is full of super glue any advice would be useful Thx
I was replacing the pins inside of my v6 but the glue came out to runny and now it cant turn with out moving the rivet and the spring is full of super glue any advice would be useful Thx
I was replacing the pins inside of my v6 but the glue came out to runny and now it cant turn with out moving the rivet and the spring is full of super glue any advice would be useful Thx
I was replacing the pins inside of my v6 but the glue came out to runny and now it cant turn with out moving the rivet and the spring is full of super glue any advice would be useful Thx
you didn't have to post that, it doesn't contribute to anybody.
maybe (i dont have any V-Cubes, so i dont know) if you pull the core and then put some paint solvent or whatever, it might find its way to the springs. just a guess, though.
srry i guess encrusted would be a better word but the glue was extremely runny and fell through the gap between the core piece and the rivet and i cant pull on the core piece enough without it breaking
Well i was pulling on it trying to break the glue but it came off so i guess i am making an adjustable core but it is goling to be harder to take out now because it is still stuck but in a smaller piece