Time to lube my cube?

Nobody here can give you a good answer to that. Just try.
Well, Like would you lube it if it looked like that?
Thats all I'm asking

I would clean it first. Take it apart and thoroughly wipe each piece clean, then lube..
Do you think jig-a-loo would work well in it?

Yes. But work it in quick.
This could have gone to the One Answer Question thread. Just post the pic.
Btw, you didn't need to make a Photobucket account. Just use
www.imageshack.us
 
Nobody here can give you a good answer to that. Just try.
Well, Like would you lube it if it looked like that?
Thats all I'm asking

I would clean it first. Take it apart and thoroughly wipe each piece clean, then lube..
Do you think jig-a-loo would work well in it?

Yes. But work it in quick.
This could have gone to the One Answer Question thread. Just post the pic.
Btw, you didn't need to make a Photobucket account. Just use
www.imageshack.us
Oh well thank you very much!
 
lubing won't hurt your cube you know...
Jig-a-loo might if you don't work it in quickly.
http://www.youtube.com/watch?v=uoa8xG69INk&safe_search=on

regular Silicone spray too you know...

I have a ruined type F because I lubed it with silicone spray. I did work it in quick, but it still just dissolved the plastic on contact. I watched the plastic "bubble." Have never had trouble with any other cube... just the F.
 
lubing won't hurt your cube you know...
Jig-a-loo might if you don't work it in quickly.
http://www.youtube.com/watch?v=uoa8xG69INk&safe_search=on

regular Silicone spray too you know...
I've heard of a lot more people compaining about jig-a-loo than regular CRC. I spray my cubes with CRC and don't work it in until 20 minutes later. I've never had a plastic problem with regular silicone. I know some people have but I was just saying that it happens more frequently with jig-a-loo (in my own experiance anyway).
 
Back
Top