Shengshou skewb!

Out of the box it sucks. Did about 150 solves. It's so fast but locks in place so hard. Cuts corners really well and I can't pop it at all even fitting a few fingers between two centres but can't pop.

I tried really hard but couldn't get the caps off to loosen it on either Skewb. It's better than most LanLans but a really well modded one is a little better.

Will keep trying to get caps off. I feel if it was a bit looser it'd be amazing, and beat any LanLan.

Overall worth the money and I'm sure I'll get caps off eventually

Can you make a review....
 
That ellipsis seems a little angry. Are you going to pay me for the review? Because I owe you nothing.

And regardless, my last post was a review, what you want is a video review.

I already stated me and Jay would video review and upload in a couple of hours

Well No I was'nt angry, I have no reason to be angry at you.....It was a request......
and i just have the habbit of typing in dots....... (ya see)
 
Last edited:
Well No I was'nt angry, I have no reason to be angry at you.....It was a request......
and i just have the habbit of typing in dots....... (ya see)
It's a bad habit.

Also, if you absolutely have to use an elipsis, use 3 dots. Not any number you want.


To Tim Major:
Was there factory lube in the cube? Does it click as much as the lanlan skewb?
 
It's a bad habit.

Also, if you absolutely have to use an elipsis, use 3 dots. Not any number you want.

It hard to get rid of bad habbits.
Okay , I'll try my best......
after this post...
..........................
..........................
kidding
but i will try my best to get rid of this habbit,
 
I can make one ^^. I don't think I will get it today cause 5 hours ago (in the morning) it was like 500km away. Tomorrow Ill go to a competition here so I most likely will make it next week around Wednesday when I had time to use the cube
 
I can make one ^^. I don't think I will get it today cause 5 hours ago (in the morning) it was like 500km away. Tomorrow Ill go to a competition here so I most likely will make it next week around Wednesday when I had time to use the cube

Thanks, Im looking forward to it
To guysensei1
I did not use ellipsis
 
Out of the box it sucks. Did about 150 solves. It's so fast but locks in place so hard. Cuts corners really well and I can't pop it at all even fitting a few fingers between two centres but can't pop.

I tried really hard but couldn't get the caps off to loosen it on either Skewb. It's better than most LanLans but a really well modded one is a little better.

Will keep trying to get caps off. I feel if it was a bit looser it'd be amazing, and beat any LanLan.

Overall worth the money and I'm sure I'll get caps off eventually

If you take a knife or something flat you can use it to pop the caps. Just push it up on one side a little, then the next side, etc. until it gets looser and you can then just pull it out. They're stuck in pretty well I must admit :)

And on loser tensions the skewb pops (I popped it after 14 solves that way :p), but the tension on my skewb is probably a bit too lose (to try to get rid of the clicking in place that is way too strong). I can't be bothered breaking it in right now, 'cause I'd rather practice mega before euro :p
 
If you take a knife or something flat you can use it to pop the caps. Just push it up on one side a little, then the next side, etc. until it gets looser and you can then just pull it out. They're stuck in pretty well I must admit :)

And on loser tensions the skewb pops (I popped it after 14 solves that way :p), but the tension on my skewb is probably a bit too lose (to try to get rid of the clicking in place that is way too strong). I can't be bothered breaking it in right now, 'cause I'd rather practice mega before euro :p

Are the center caps glued on? Or are they just tough to get off?

If they are glued, to they go back on after breaking the glue?
 
Are the center caps glued on? Or are they just tough to get off?

If they are glued, to they go back on after breaking the glue?

Usually if they're right enough that they take a knife to pry off, they take either paper or glue or something to stay on.

anyway, this looks basically like mine without 500 years of modding, so that's good..
 
This is my first skewb, i loosened it up a bit and it seems to be fine. then again im a mediocre solver on this so take my opinions lightly. ya the click is a little heavy but when i loosened the screws it got a lot better.
 
Back
Top