Robot - edges of cubes bind

Status
Not open for further replies.

Ryouko

Member
Joined
May 28, 2008
Messages
7
Hey guys, I have been building a robot for one of my classes that should be able to solve a cube. We have gotten pretty far, and here is our current problem:
The layers are sometimes off by the slightest amount after a move is done. If the layer is off in the right direction the cube will just correct itself (sprung core), however, if the layer is off in the wrong direction it binds and won't turn.

My ideas for possible solutions so far are:
-Add square pieces of metal that will hit two faces of the cube after every move to try to get it perfectly aligned (+ should get it lined up; - needs new hardware, may not work)
-Add some code to make the motor always under/over turn in the correct direction based on the following turn (+ software changes are free, no new hardware; - may be too hard to make sure it is overturned in the right direction)

Any suggestions you guys have would be great, sorry I don't have any videos or pictures up to give you an idea of what I am working with, Ill post some later.
 
get a better cube. This will make it so you don't need to add additional hardware to the cube and is much less work. If you decide to do this i suggest a GuHong, And although I've never used it it seems to be the best option for what you're looking for.
 
Status
Not open for further replies.
Back
Top